Product manual

source-ip-vlan

■ [no] router pim bsr-candidate source-ip-vlan VLAN-ID

Specify the VLAN to use as a source for Candidate-BSR router IP address

(PIM-SM must be enabled on this VLAN).

■ [no] router pim rp-candidate source-ip-vlan VLAN-ID

Specify the VLAN to use as a source for Candidate-RP router IP address

(PIM-SM must be enabled on this VLAN).

Next Available Option:

■ group-prefix -- Specify the multicast group prefix to associate with the Candidate-RP router.

(p. 415)

spt-threshold

■ [no] router pim spt-threshold

Usage: [no] spt-threshold

Description: Specify whether switching to the Shortest Path Tree is enabled

or disabled on the router. Default is 'enabled'.

state-refresh

■ router pim state-refresh < 10 to 300 >

Usage: state-refresh <10-300>

Description: Set the interval between successive State Refresh messages

originated by this router. Default value is 60 seconds.

Range: < 10 to 300 >

stub

■ router ospf area OSPF-AREA-ID stub

Dene a "stub" area and specify its cost.

Next Available Options:

■ cost < 0 to 16777215 > -- Enter cost to use when injecting default routes into the area.(p. 413)

■ no-summary -- Do not send summary LSA into the area.(p. 418)

■ router ospf area backbone stub

Dene a "stub" area and specify its cost.

Next Available Options:

■ cost < 0 to 16777215 > -- Enter cost to use when injecting default routes into the area.(p. 413)

■ no-summary -- Do not send summary LSA into the area.(p. 418)

transit-delay

■ router ospf area OSPF-AREA-ID virtual-link IP-ADDR transit-delay < 1 to 3600 >

routerCommand Line Interface Reference Guide