Product manual

no bsr-candidate [source-ip-vlan <VLAN-ID>]
Description: Congure the router to advertise itself as the Candidate
Bootstrap Router (Candidate-BSR) for a PIM-SM domain. When
enabling router to be a Candidate-BSR the VLAN ID must be
specied, which IP address will be advertised as a
Candidate-BSR address. PIM-SM must be enabled on the VLAN.
Use 'no' form of this command to disable the router to be a
Candidate-BSR.
NOTE: It is recommended that the same routing switch is
congured as both the Candidate-BSR and the Candidate-RP.
Parameters:
o source-ip-vlan <VLAN-ID> - The VLAN which IP address will be advertised
as the Candidate-BSR IP address.
o hash-mask-length <1-32> - The mask length (in bits) used by the
PIM-SM hash function when selecting an RP. The default is 30.
o priority <0-255> - The priority for the Candidate-BSR for the
local PIM-SM domain. The larger value means the higher priority.
The default is 0.
o bsm-interval <5-300> - The interval (in seconds) for sending periodic
Bootstrap messages on all PIM-SM interfaces, when this router is
the elected BSR. The default is 60 seconds.
Next Available Options:
■ source-ip-vlan -- Specify the VLAN to use as a source for Candidate-BSR router IP address
(PIM-SM must be enabled on this VLAN). (VLAN-ID) (p. 424)
■ hash-mask-length < 1 to 32 > -- Specify the length (in bits) of the hash mask. (p. 415)
■ priority < 0 to 255 > -- Specify the priority for the Candidate Bootstrap router. (p. 420)
■ bsm-interval < 5 to 300 > -- Specify the interval for sending Bootstrap messages on PIM-SM
interfaces. (p. 412)
chain-name
■ router ospf area OSPF-AREA-ID virtual-link IP-ADDR md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
■ router ospf area backbone virtual-link IP-ADDR md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
cost
■ router ospf area OSPF-AREA-ID stub < 0 to 16777215 >
Enter cost to use when injecting default routes
into the area.
Range: < 0 to 16777215 >
■ router ospf area backbone stub < 0 to 16777215 >
Enter cost to use when injecting default routes
into the area.
Range: < 0 to 16777215 >
413© 2008 Hewlett-Packard Development Company, L.P.
routerCommand Line Interface Reference Guide