Product manual
Usage: lldp refresh-interval <5-32768>
Description: Set refresh interval/transmit-interval in seconds.
The default is 30.
The refresh interval/transmit-interval should be greater
than or equal to (4*delay-interval).
The default value of delay-interval is 2.
Range: < 5 to 32768 >
run
■ [no] lldp run
Usage:[no] lldp run
Description: Start or Stop LLDP on device.
top-change-notify
■ [no] lldp top-change-notify [ETHERNET] PORT-LIST
Usage:[no] lldp top-change-notify <port-list>
Description: Set the port for which LLDP MED topology notication should be enabled.
vlan-base
■ lldp auto-provision radio-ports vlan-base < 2 to 4094 >
Assign the default value of the VLAN id to be used if an
auto-generated VLAN is created for a radio-port application.
Range: < 2 to 4094 >
vlan-name
■ [no] lldp config [ETHERNET] PORT-LIST dot1TlvEnable vlan-name
Specify that the VLAN name TLV is to be advertised. Enables LLDP VLAN TLV advertisements
on an
individual port or range of ports. The advertisements are sent out each congured
port at the
congured frequency. The default frequency is every 30 seconds.
Note: To change the default frequency, use the "lldp refresh-interval" command.
WHAT
■ lldp config [ETHERNET] PORT-LIST medPortLocation civic-addr COUNTRY NUMBER
Specify the 'what' number of range <0-2>.
Next Available Option:
■ CA-TYPE -- Specify the ca-type value of range <0-255>. (NUMBER) (p. 332)
336© 2008 Hewlett-Packard Development Company, L.P.
lldpCommand Line Interface Reference Guide