Product manual

■ [no] lldp enable-notification -- Set the port for which notification should be enabled ([ethernet]
PORT-LIST) (p. 334)
■ lldp fast-start-count < 1 to 10 > -- Set MED fast-start count in seconds (NUMBER) (p. 334)
■ lldp holdtime-multiplier < 2 to 10 > -- Set holdtime-multipler between <2-10>; the default is 4
(NUMBER) (p. 334)
■ lldp refresh-interval < 5 to 32768 > -- Set refresh interval/transmit-interval in seconds (NUMBER)
(p. 335)
■ [no] lldp run -- Start or Stop LLDP on device (p. 336)
■ [no] lldp top-change-notify -- Set the port for which LLDP MED topology notification should be
enabled ([ethernet] PORT-LIST) (p. 336)
EXAMPLES
Example: lldp config basicTlvEnable
Exclude the system name from the outbound LLDP advertisements for all ports:
ProCurve(cong)# no lldp cong A1-A24 basicTlvEnable system_name
Example: lldp config ipAddrEnable
Use a secondary IP address in LLDP advertisements. In this example, use secondary IP address
10.10.10.100, which is on a subnetted VLAN that contains port 3:
ProCurve(cong)# lldp cong 3 ipAddrEnable 10.10.10.100
Example: lldp enable-notification
Enable SNMP notification on ports 1 - 5:
ProCurve(cong)# lldp enable-notication A1-A5
Example: lldp holdtime-multiplier
If the refresh interval on the switch is 15 seconds and the holdtime multiplier is at the default, the
Time-to-Live for advertisements transmitted from the switch is 60 seconds (4 * 15). To reduce the
Time-to-Live, lower the holdtime-interval to 2, which results in a Time-to-Live of 30 seconds:
ProCurve(cong)# lldp holdtime-multiplier 2
Example: lldp run
Disable LLDP on the switch:
ProCurve(cong)# no lldp run
COMMAND DETAILS
omodes (p. 335)COUNTRY (p. 333)addr (p. 331)
radio-ports (p. 335)dot1TlvEnable (p. 333)admin-status (p. 331)
refresh-interval (p. 335)dot3TlvEnable (p. 334)auto (p. 331)
run (p. 336)elin-addr (p. 334)auto-provision (p. 331)
top-change-notify (p. 336)enable-notification (p. 334)auto-vlan (p. 331)
vlan-base (p. 336)fast-start-count (p. 334)basicTlvEnable (p. 332)
vlan-name (p. 336)holdtime-multiplier (p. 334)CA-TYPE (p. 332)
WHAT (p. 336)ipAddrEnable (p. 334)CA-VALUE (p. 332)
medPortLocation (p. 334)civic-addr (p. 332)
330© 2008 Hewlett-Packard Development Company, L.P.
lldpCommand Line Interface Reference Guide