Product manual

No additional parameters are required when 'no' is specied.

Parameters:

o <dhcp|manual> - The method the switch uses to acquire

the Timep server address: dhcp - from a DHCP server; manual - you

manually enter the Timep server address; disable (which is set by

specifying the 'no' parameter) - the switch will not attempt to get

its time from a Timep server.

o [interval <1-9999>] (default is 720) How often (in minutes) the

switch tries to get the current time.

o [server <IP-ADDR>] - The IPv4 address of the Timep server that the

switch gets the current time from.

o [server <IPV6-ADDR>] - The IPv6 address of the Timep server that the

switch gets the current time from.

Next Available Options:

■ dhcp -- Use DHCP to acquire Timep server address.(p. 275)

■ manual -- Manually configure the Timep server address.(p. 282)

ttl

■ ip ttl < 2 to 255 >

Usage: ip ttl <2-255>

Description: Specify TTL for outgoing IP packets.

Range: < 2 to 255 >

udp-bcast-forward

■ [no] ip udp-bcast-forward

Usage: [no] ip udp-bcast-forward

Description: Enable/disable UDP broadcast forwarding.

unreachable

■ [no] ip icmp unreachable

Usage: [no] ip icmp unreachable

Description: Enable/disable destination unreachable error messages.

vlan

■ ip source-binding VLAN-ID

Next Available Option:

■ ip -- (IP-ADDR) (p. 280)

■ [no] ip route IP-ADDR/MASK-LENGTH vlan VLAN-ID

Specify the destination VLAN.

ipCommand Line Interface Reference Guide