Product manual

■ ipv6 -- Configure various IP parameters for the VLAN(p. 230)
■ auto -- Cause each port identified in the port list to learn its VLAN membership using the GARP
VLAN Registration Protocol (GVRP) ([ethernet] PORT-LIST) (p. 212)
■ connection-rate-filter -- Re-enables access to a host or set of hosts that has been previously
blocked by the connection rate filter(p. 215)
■ monitor -- Define either the VLAN is to be monitored or not(p. 238)
■ name -- Set the VLAN's name (ASCII-STR) (p. 242)
■ protocol -- Set a predefined protocol for the current VLAN. (p. 253)
■ qos -- Set VLAN-based priority(p. 254)
■ tagged -- Assign ports to current VLAN as tagged ([ethernet] PORT-LIST) (p. 263)
■ untagged -- Assign ports to current VLAN as untagged ([ethernet] PORT-LIST) (p. 266)
■ forbid -- Prevent ports from becoming a member of the current VLAN ([ethernet] PORT-LIST)
(p. 220)
■ voice -- Labels this VLAN as a Voice VLAN, allowing you to separate, prioritize, and authenticate
voice traffic moving through your network(p. 267)
■ jumbo -- Labels this VLAN as a Jumbo VLAN, allowing you to pass packets up to 9220 bytes
in size(p. 232)
tagged
■ [no] interface vlan VLAN-ID tagged [ETHERNET] PORT-LIST
Usage: [no] tagged [ethernet] PORT-LIST
Description: Assign ports to current VLAN as tagged.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
■ [no] interface svlan VLAN-ID tagged [ETHERNET] PORT-LIST
Usage: [no] tagged [ethernet] PORT-LIST
Description: Assign ports to current VLAN as tagged.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
timer-interval
■ interface vlan VLAN-ID ip-recv-mac-address MAC-ADDR interval < 1 to 255 >
Timeout interval in seconds <1-255>.
Range: < 1 to 255 >
transit-delay
■ interface vlan VLAN-ID ip ospf transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
■ interface vlan VLAN-ID ip ospf IP-ADDR transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
263© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide