Product manual

Obtain IPv6 address quickly from DHCPv6 server.
■ [no] interface svlan VLAN-ID ipv6 address dhcp full rapid-commit
Obtain IPv6 address quickly from DHCPv6 server.
rate-limit
■ interface [ETHERNET] PORT-LIST rate-limit
Usage: rate-limit icmp <percent <0-100> | kbps <0-10000000>>
rate-limit all <in|out> <percent <0-100> | kbps <0-10000000>>
rate-limit ip access-group <acl-name> in kbps <0-10000000>
no rate-limit <icmp| all <in|out>| ip access-group>>
Description: Enable/disable and congure rate-limiting for all trafc
(or for incoming ICMP trafc) on the port(s). By default,
rate-limiting is disabled on all ports. When a port is
congured to rate-limit trafc, it forwards only that
specied amount of trafc (percentage, bits-per-second, or
kilobits-per-second). The remaining over-prole trafc of the
type being rate-limited is then discarded.
Rate-Limiting works on inbound ICMP trafc, or on inbound or
outbound trafc in general. The rate-limit reects the
permitted forwarding rate of the trafc type. It is visible as
the average rate of the outbound trafc (or outbound ICMP
trafc) originating from the rate-limited port (when in inbound
mode), or as the average rate of the outbound trafc from an
outbound rate-limited port.
Rate-limiting of all trafc is primarily used for end-node
connections (i.e., at the network edge). It is not recommended
for use on links to servers, routers, switches, or the network
backbone or core.
(Rate-limiting all trafc on such links can interfere with
important network functions.)
ICMP rate-limiting is primarily used for throttling worm or virus-
like behavior, and should NOT be used to remove all ICMP trafc
from the network, as this protocol is necessary for routing
functions.
For more detailed information on rate-limiting, please consult
the product manual.
This is an Interface context command. It can be called directly
from the interface context, or following the
'interface [ethernet] PORT-LIST' command.
Next Available Options:
■ icmp -- Set limits for ICMP traffic only.(p. 224)
■ all -- Set limits for all traffic.(p. 207)
■ ip -- Apply the specified access control list to inbound packets on this INTERFACE list(p. 225)
receive
■ interface vlan VLAN-ID ip rip receive < V1-only | V2-only | V1-or-V2 | ... >
258© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide