Product manual

■ IPX -- IPX Protocol Group
■ IPv4 -- IP version 4 Protocol Group
■ IPv6 -- IP version 6 Protocol Group
■ ARP -- Address Resolution Protocol Group
■ Appletalk -- Appletalk Protocol Group
■ SNA -- System Network Architecture Protocol Group
■ NetBEUI -- Network BIOS Enhanced User Interface Protocol Group
provider-network
■ interface [ETHERNET] PORT-LIST qinq port-type provider-network
Congure qinq port-type as provider-network
proxy-arp
■ [no] interface vlan VLAN-ID ip proxy-arp
Usage: [no] ip proxy-arp
Description: Enable/disable proxy ARP. This is a VLAN context command.
It can be called directly from the VLAN context or may follow
the 'vlan VLAN-ID' command prex. When proxy ARP is enabled on
a VLAN, the device responds to ARP requests received on the
VLAN ports when the device knows a route to the requested IP
addresses.
qinq
■ interface [ETHERNET] PORT-LIST qinq
Usage: qinq port-type <cn-customer-network-port|pn-provider-network-port>
Description: Congure a port's type as customer-network or provider-network.
In svlan mode, the default port type is 'provider-network'. In
mixedvlan mode, default for SVLAN ports is 'provider-network'.
Conguring a port as either customer-network or provider-network
is applicable only if the device is congured in either svlan or
mixedvlan mode.
Next Available Option:
■ port-type -- Configure qinq port-type(p. 249)
qos
■ [no] interface [ETHERNET] PORT-LIST qos
Usage: [no] qos [dscp <000000|000001...111111> | priority <0-7>]
Description: Set port-based priority. The 'dscp' or 'priority' must be
specied if 'no' is not used. Using 'no' congures the device
not to apply a source-port priority to this port's packets.
This is an Interface context command. It can be called directly
from the interface context or follow the 'interface [ethernet]
PORT-LIST' command.
Next Available Options:
■ dscp < 000000 | 000001 | 000010 | ... > -- Specify DSCP policy to use. (p. 218)
254© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide