Product manual

■ max-graft-retries < 1 to 10 > -- Set the maximum number of times this router will resend a
Graft on this interface(p. 235)
■ override-interval < 500 to 6000 > -- Set the value inserted into the Override Interval field of a
LAN Prune Delay option on this interface(p. 244)
■ propagation-delay < 250 to 2000 > -- Set the value inserted into the LAN Prune Delay field of
a LAN Prune Delay option on this interface(p. 252)
■ ttl-threshold < 0 to 255 > -- Set the Time To Live in a PIM-DM State Refresh message at which
it is not forwarded on this interface(p. 264)
pim-sparse
■ [no] interface vlan VLAN-ID ip pim-sparse
Usage: [no] ip pim-sparse [...]
Description: Enable/disable/congure PIM-SM protocol on the VLAN interface.
Use direct and 'no' versions of the command to enable/disable
PIM-SM on the interface. Use 'ip pim-sparse ?' to get the list
of all conguration options. This command can be used in the
VLAN context or in the global context with the 'vlan <VLAN-ID>'
prex.
Next Available Options:
■ ip-addr -- Set the source IP address for the PIM-SM packets sent out on this interface(p. 227)
■ lan-prune-delay -- Turn on/off the LAN Prune Delay Option on this interface(p. 233)
■ hello-interval < 5 to 300 > -- Set the frequency at which PIM Hello messages are transmitted
on this interface(p. 222)
■ hello-delay < 0 to 5 > -- Set the maximum time before a triggered PIM Hello message is
transmitted on this interface(p. 222)
■ override-interval < 500 to 6000 > -- Set the value inserted into the Override Interval field of a
LAN Prune Delay option on this interface(p. 244)
■ propagation-delay < 250 to 2000 > -- Set the value inserted into the LAN Prune Delay field of
a LAN Prune Delay option on this interface(p. 252)
■ dr-priority -- Set the priority value to use on the interface in the Designated Router election
process(p. 218)
■ nbr-timeout < 60 to 8000 > -- Set the neighbour loss time interval for this interface(p. 242)
poe_lldp_detect
■ interface [ETHERNET] PORT-LIST poe-lldp-detect < disabled | enabled >
Usage: poe-lldp-detect [disabled|enabled]
Description: Enabling this feature causes the port to allocate power
based on the link-partner's capabilities via LLDP.
By default, poe information detected though LLDP
are ignored as not all PoE devices properly support LLDP.
Supported Values:
■ disabled
■ enabled
poe_value
■ interface [ETHERNET] PORT-LIST poe-value < 1 | 2 | 3 | ... >
246© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide