Product manual

Usage: vrrp vrid <VRID> owner
Description: Designate the virtual router instance as an Owner (Master).
There is no default value.
passive
■ [no] interface vlan VLAN-ID ip ospf passive
Congures an ospf interface as passive.
■ [no] interface vlan VLAN-ID ip ospf IP-ADDR passive
Congures an ospf interface as passive.
■ [no] interface vlan VLAN-ID ip ospf all passive
Congures an ospf interface as passive.
percent
■ interface [ETHERNET] PORT-LIST rate-limit icmp percent < 0 to 100 >
Specify limit as percent of inbound or outbound trafc.
Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit all in percent < 0 to 100 >
Specify limit as percent of inbound or outbound trafc.
Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit all out percent < 0 to 100 >
Specify limit as percent of inbound or outbound trafc.
Range: < 0 to 100 >
pim-dense
■ [no] interface vlan VLAN-ID ip pim-dense
Usage: [no] ip pim-dense [...]
Description: Enable/disable/congure PIM-DM protocol on the VLAN interface.
Use direct and 'no' versions of the command to enable/disable
PIM-DM on the interface. Use 'ip pim-dense ?' to get the list
of all conguration options. This command can be used in the
VLAN context or in the global context with the 'vlan <VLAN-ID>'
prex.
Next Available Options:
■ ip-addr -- Set the source IP address for the PIM-DM packets sent out on this interface(p. 227)
■ lan-prune-delay -- Turn on/off the LAN Prune Delay Option on this interface(p. 233)
■ hello-interval < 5 to 300 > -- Set the frequency at which PIM Hello messages are transmitted
on this interface(p. 222)
■ hello-delay < 0 to 5 > -- Set the maximum time before a triggered PIM Hello message is
transmitted on this interface(p. 222)
■ graft-retry-interval < 1 to 10 > -- Set the interval a PIM router waits for a Graft Ack before
resending a Graft on this interface(p. 222)
245© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide