Product manual

■ [no] interface [ETHERNET] PORT-LIST rate-limit ip access-group
Usage: [no] ip access-group <ACL-ID> in
Description: Apply the specied access control list to inbound
packets on this INTERFACE list. The access
control list ACL-ID must be dened before it can be applied.
Next Available Option:
■ access-group -- Apply the specified access control list to inbound packets on this INTERFACE
list (ASCII-STR) (p. 201)
■ interface [ETHERNET] PORT-LIST rate-limit ip access-group ACCESS-GROUP
Usage: [no] ip access-group <ACL-ID> in
Description: Apply the specied access control list to inbound
packets on this INTERFACE list. The access
control list ACL-ID must be dened before it can be applied.
Next Available Option:
■ direction < in > -- (p. 217)
■ [no] interface vlan VLAN-ID ip access-group ACCESS-GROUP
Usage: [no] ip access-group <ACL-ID> <in|out>
in Match packets this device will route to another VLAN
out Match packets this device will route onto this VLAN
vlan Match packets that originate within this VLAN
connection-rate-lter Manage new conection rates originating in this VLAN
Description: Apply the specied access control list on this VLAN interface.
The ACL can match either packets that are routed from this VLAN
to another VLAN, packets that will be routed from another VLAN
to this VLAN, packets that originate on this VLAN, or it can
manage new connection rates for virus throttling.
Next Available Option:
■ direction < in | out | connection-rate-filter | ... > -- (p. 217)
■ interface vlan VLAN-ID monitor ip access-group ACCESS-GROUP
Usage: [no] mirror-port [[ethernet] PORT-NUM]
Description: Dene the mirror port for diagnostic purposes. The device
ports or VLAN (if VLANs are enabled on the device) that will
be monitored are dened through the 'monitor' command in
either VLAN or interface context.
The network trafc seen by the monitored ports is copied to
the mirror port to which a network analyzer can be attached.
When mirroring multiple ports in a busy network,
some frames may not be copied to the monitoring port.
Parameters: PORT-NUM - Port that will be acting as the monitoring port. It
cannot be a trunked port. The parameter must be specied,
202© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide