Product manual

monitor_mirror_session_id (p.
241)
enable (p. 219)
eui-64 (p. 219)
speed-duplex (p. 261)
src-ip (p. 262)
mroute (p. 242)fastleave (p. 219) svlan (p. 262)
name (p. 242)flow-control (p. 220) tagged (p. 263)
nbr-timeout (p. 242)forbid (p. 220) timer-interval (p. 263)
no-default (p. 243)forcedfastleave (p. 220) transit-delay (p. 263)
number (p. 243)forward (p. 221) trust (p. 264)
ospf (p. 243)forward-protocol (p. 221) ttl-threshold (p. 264)
out (p. 244)full (p. 221) type (p. 264)
output (p. 244)graft-retry-interval (p. 222) udp (p. 265)
override-interval (p. 244)gvrp (p. 222) unblock (p. 265)
owner (p. 244)hello-delay (p. 222) unknown-vlans (p. 265)
passive (p. 245)hello-interval (p. 222) untagged (p. 266)
percent (p. 245)helper-address (p. 223) virtual-ip-address (p. 266)
pim-dense (p. 245)high-priority-forward (p. 223) vlan (p. 266)
pim-sparse (p. 246)holdtime (p. 223) voice (p. 267)
poe_lldp_detect (p. 246)host (p. 224) vrid (p. 268)
poe_value (p. 246)icmp (p. 224) vrrp (p. 268)
poe-allocate-by (p. 247)igmp (p. 224)
poe-lldp-detect (p. 247)
access-group
■ [no] interface [ETHERNET] PORT-LIST ip access-group ACCESS-GROUP
Usage: [no] ip access-group <ACL-ID> in
Description: Apply the specied access control list to inbound
packets on this INTERFACE list. The access
control list ACL-ID must be dened before it can be applied.
Next Available Option:
■ direction < in > -- (p. 217)
■ interface [ETHERNET] PORT-LIST monitor ip access-group ACCESS-GROUP
Usage: [no] mirror-port [[ethernet] PORT-NUM]
Description: Dene the mirror port for diagnostic purposes. The device
ports or VLAN (if VLANs are enabled on the device) that will
be monitored are dened through the 'monitor' command in
either VLAN or interface context.
The network trafc seen by the monitored ports is copied to
the mirror port to which a network analyzer can be attached.
When mirroring multiple ports in a busy network,
some frames may not be copied to the monitoring port.
Parameters: PORT-NUM - Port that will be acting as the monitoring port. It
cannot be a trunked port. The parameter must be specied,
if the 'no' keyword is not used. Otherwise, it must not be
present.
Next Available Option:
■ monitor_mirror_ACL_dir < In > -- Define the mirror port for diagnostic purposes(p. 240)
201© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide