Product manual

■ connection-rate-filter -- Re-enables access to a host or set of hosts that has been previously
blocked by the connection rate filter (p. 215)
■ unblock -- Resets a host previously blocked by the connection rate filter (p. 265)
■ all -- Resets all previously blocked by the connection rate filter (p. 207)
■ host -- Match packets from the specified IP address. (IP-ADDR) (p. 224)
■ src-ip -- Match packets from the specified subnet. (IP-ADDR/MASK-LENGTH) (p. 262)
■ dhcp-snooping -- (p. 217)
■ forbid -- Prevent ports from becoming a member of the current VLAN ([ethernet] PORT-LIST)
(p. 220)
■ igmp-proxy -- Associate an IGMP proxy domain with a VLAN (p. 224)
■ domain-name < END OF PRINTABLE > -- Specify the domain name to associate/disassociate
with the VLAN. (ASCII-STR) (p. 218)
■ ip -- Configure various IP parameters for the VLAN (p. 225)
■ access-group -- Apply the specified access control list on this VLAN interface (ASCII-STR)
(p. 201)
■ direction < in | out | connection-rate-filter | ... > -- (p. 217)
■ address -- Set IP parameters for communication within an IP network (p. 203)
■ dhcp-bootp -- Configure the interface to use DHCP/Bootp server to acquire parameters.
(p. 217)
■ ip-addr -- Interface IP address/mask. (IP-ADDR/MASK-LENGTH) (p. 227)
■ forward-protocol -- Add or remove a UDP server address for the VLAN (p. 221)
■ udp -- Add or remove a UDP server address for the VLAN (p. 265)
■ ip-addr -- IP address of the protocol server. (IP-ADDR) (p. 227)
■ port-name < dns | ntp | netbios-ns | ... > -- (NUMBER) (p. 249)
■ port-num -- UDP port number of the server. (TCP/UDP-PORT) (p. 249)
■ helper-address -- Add or remove a DHCP server IP address for the VLAN (IP-ADDR) (p. 223)
■ igmp -- Enable/disable/configure IP Multicast Group Protocol (IGMP) feature on a VLAN (p.
224)
■ auto -- Instruct the device to monitor incoming multicast traffic on the specified ports
(this is the default behavior) ([ethernet] PORT-LIST) (p. 212)
■ blocked -- Instruct the device to drop incoming multicast packets received on the specified
ports ([ethernet] PORT-LIST) (p. 214)
■ fastleave -- Enables or disables IGMP Fast Leaves ([ethernet] PORT-LIST) (p. 219)
■ forcedfastleave -- When enabled, this feature forces IGMP Fast Leaves to occur even
when the port is cascaded ([ethernet] PORT-LIST) (p. 220)
■ forward -- Instruct the device to forward incoming multicast packets received on the
specified ports ([ethernet] PORT-LIST) (p. 221)
■ high-priority-forward -- Enable/disable the high priority forwarding of traffic for subscribed
IP Multicast groups (p. 223)
■ querier -- Specify querier/non-querier capability for the VLAN (p. 255)
■ interval < 5 to 300 > -- Sets the interval in seconds between IGMP queries (default:
125) (p. 225)
■ irdp -- Configure ICMP Router Discovery Protocol (IRDP) (p. 231)
■ advert-address < multicast | broadcast > -- Specify the destination address to be used
for router advertisements (p. 206)
■ holdtime < 4 to 9000 > -- Set the lifetime (in seconds) of the router advertisements sent
on this interface (p. 223)
■ maxadvertinterval < 4 to 1800 > -- Set the maximum time (in seconds) allowed between
sending unsolicited router advertisements (p. 235)
■ minadvertinterval < 3 to 1800 > -- Set the minimum time (in seconds) allowed between
sending unsolicited router advertisements (p. 236)
■ preference -- The preferability of the router as a default router, relative to the other
routers on the same subnet (p. 250)
195© 2008 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide