Specifications
Table Of Contents
- HP 8200 zl Switches
- Installation and Getting Started Guide
- Contents
- Introducing the HP 8200 zl Switches
- Installing the HP 8200 zl Switches
- Included Parts
- Power Cords
- Installation Procedures
- Summary
- Installation Precautions
- 1. Prepare the Installation Site
- 2. Mount the Switch Chassis
- 3. Install the Switch Modules
- 4. Install the Power Supplies
- 5. Verify the Switch Passes Self Test
- 6. Install the Grounding Wire
- 7. Connect the Switch to a Power Source
- 8. (Optional) Connect a Power Supply Shelf to the switch
- 9. Connect the Network Devices
- 10. (Optional) Connect a Console to the Switch
- Hot Swapping Switch Modules
- Example Network Topologies
- Getting Started With Switch Configuration
- Replacing Components
- Troubleshooting
- Specifications
- Switch Ports and Network Cables
- Cabling and Technology Information Specifications
- Mode Conditioning Patch Cord
- Twisted-Pair Cable/Connector Pin-Outs
- Safety and Regulatory Statements
- Recycle Statements
- Index
- Installation and Getting Started Guide

v
3 Getting Started With Switch Configuration
Recommended Minimal Configuration ..........................3-1
Using the Switch Setup Screen ................................3-2
Where to Go From Here ......................................3-4
To Recover from a Lost Manager Password: .................3-4
Using the IP Address for Remote Switch Management ................3-5
Starting a Telnet Session .....................................3-5
Starting a Web Browser Session ...............................3-5
Configuring the ProCurve Wireless Edge Services zl Module (J9051A) . . 3-7
Configuring an IP Address for the Module .......................3-7
Configuring VLANs on the zl Switch ............................3-9
Determining a Module Configuration Backup Process ............3-9
Configuring Wireless LAN Services ...........................3-10
4 Replacing Components
Replacing Power Supplies ........................................4-2
Replacing Fan Trays .............................................4-5
Replacing the Management Module ................................4-6
Replacing the Management Module Compact Flash Card .............4-8
Installing a Compact Flash Card ...............................4-8
Replacing the Services Module Compact Flash Card .................4-9
Installing a Compact Flash Card ...............................4-9
Replacing the Services Module Disk Drive .........................4-10
Installing a Disk Drive ......................................4-10
5 Troubleshooting
Basic Troubleshooting Tips ......................................5-1
Diagnosing with the LEDs ........................................5-4
Proactive networking ............................................5-9
Hardware Diagnostic Tests ......................................5-10
Reasons for Resetting the Switch .............................5-10