Specifications

Table Of Contents

4-1

Replacing Components

This chapter shows you how to remove and install the following components:

■ Power supplies (see page 4-2)

■ Fan tray (see page 4-5)

■ Management module (see page 4-6)

■ Management module Flash Disk (see page 4-8)

■ Replacing the Services zl Module Compact Flash Card (see page 4-9)

■ Replacing the Services zl Module Disk Drive (see page 4-10)

For a complete list of parts and part numbers, see page 2-1.

Hot Swapping The HP 8200 zl switches support “hot swapping.” Hot swapping is the ability

to replace certain hardware components while the switch is operating,

including a fan tray, power supply (if a second power supply is installed), and

certain modules.

The System Support module is not hot swappable. The Management module

and its components are not hot swappable unless there are two Management

modules installed in the switch. The Fabric modules can be hot swapped one

at a time.

The hot swapping feature allows you to remove or install modules without

powering off or rebooting the switch. Swapped-in modules are recognized by

the switch and begin functioning immediately after they are installed.

Caution The HP E8200 zl switch and its components are sensitive to static discharge.

Use an antistatic wrist strap and observe all static precautions when hot

swapping components. For example, connect your antistatic wrist strap to the

ground point on the front of the switch, above the rightmost power supply bay.

WARNING This unit may have more than one power supply cable. To fully power

down the switch, you must disconnect all power supply cables from the

unit.