Specifications
Table Of Contents
- HP 8200 zl Switches
- Installation and Getting Started Guide
- Contents
- Introducing the HP 8200 zl Switches
- Installing the HP 8200 zl Switches
- Included Parts
- Power Cords
- Installation Procedures
- Summary
- Installation Precautions
- 1. Prepare the Installation Site
- 2. Mount the Switch Chassis
- 3. Install the Switch Modules
- 4. Install the Power Supplies
- 5. Verify the Switch Passes Self Test
- 6. Install the Grounding Wire
- 7. Connect the Switch to a Power Source
- 8. (Optional) Connect a Power Supply Shelf to the switch
- 9. Connect the Network Devices
- 10. (Optional) Connect a Console to the Switch
- Hot Swapping Switch Modules
- Example Network Topologies
- Getting Started With Switch Configuration
- Replacing Components
- Troubleshooting
- Specifications
- Switch Ports and Network Cables
- Cabling and Technology Information Specifications
- Mode Conditioning Patch Cord
- Twisted-Pair Cable/Connector Pin-Outs
- Safety and Regulatory Statements
- Recycle Statements
- Index
- Installation and Getting Started Guide
2-1
Installing the HP 8200 zl
Switches
2
Installing the HP 8200 zl Switches
The 8200 zl switches are easy to install. Each comes with an accessory kit that
includes the brackets for mounting the switch in a standard 19-inch telco rack,
or in an equipment cabinet. The switch has rubber feet already attached so
they can be securely located on a horizontal surface. This chapter tells you
how to install your 8212 zl or 8206 zl switch.
WARNING To avoid possible personal injury, be careful when lifting the chassis
out of the shipping box. The Switch 8212 zl chassis base system weighs
approximately 50.45 pounds as shipped and 44.75 pounds when empty.
See “Installation Precautions” on page 2-5 for additional safety
considerations when handling this product.
Included Parts
The following components are shipped with the 8200 zl switches:
■ HP 8212 zl Quick Setup Guide or HP 8206 zl Quick Setup Guide
■ HP 8200 zl Safety and Regulatory Information
■ Accessory kit (5070-6865 for the 8206 zl or 5070-2983 for the 8212 zl):
• two mounting brackets
• eight 10 mm M4 screws to attach the mounting brackets to the switch
• eight 5/8-inch number 12-24 screws to attach the switch to a rack
■ Console cable