Product guide

IP Routing Features
Configuring RIP
See “RIP Interface Information” on the previous page for definitions of these
fields.
You can also display the information for a single RIP VLAN interface, by
specifying the VLAN ID for the interface, or specifying the IP address for the
interface.
Displaying RIP interface information by VLAN ID: For example, to
show the RIP interface information for VLAN 1000, use the show ip rip interface
vlan < vid > command.
Figure 5-5. Example of RIP Interface Output by VLAN
The information in this display includes the following fields, which are defined
under ““RIP Interface Information” on page 5-35: IP Address, Status, Send
mode, Recv mode, Metric, and Auth.
The information also includes the following fields:
■ Bad packets received – The number of packets that were received on
this interface and were not processed for any reason.
■ Bad routes received – The number of route entries that were received
on this interface and were not processed for any reason.
■ Sent updates – The number of RIP routing updates that have been sent
on this interface.
Displaying RIP interface information by IP Address: For example, to
show the RIP interface information for the interface with IP address 100.2.0.1,
enter the show ip rip interface command as shown below:
5-36