Installation guide

Fan tray
HP ProCurve Switch 8200zl/5400zl series fan trays
can be hot-swapped without system disruption as long
as the new tray is installed within three minutes of the
previous tray being removed.
Replacing the HP ProCurve Switch 3500 or Switch
6200yl series fan tray requires that the switch be
removed from the rack, power removed, and the top
of the switch opened.
Part number
HP ProCurve Switch 8206zl Fan Tray J9476A
HP ProCurve Switch 8212zl Fan Tray J9094A
HP ProCurve Switch 5406zl Fan Tray J8697-60005
HP ProCurve Switch 5412zl Fan Tray J8698-60005
HP ProCurve Switch 3500/6200yl Fan Tray 5069-8598
Spare 8200zl fabric module
HP ProCurve Switch 8200zl series base systems ship
with required fabric modules, but spare modules can
be ordered to be on hand in the event of a failure.
One fabric module is required, and replacement
fabric modules can be swapped out during switch
operation with minimal interruption to switch service.
Part number
HP ProCurve Switch 8200zl Fabric Module J9093A
Spare 8200zl system support module
The HP ProCurve Switch 8200zl series requires a
system support module (SSM), and spare modules
can be ordered because this module is a critical
system component. The spare SSM ships with the tool
required for removal of the SSM from the 8200zl
chassis, and replacement should be done during a
scheduled maintenance window because the SSM is
not a hot-swappable component.
Part number
HP ProCurve Switch 8200zl System Support
Module
J9095A
Rack-mounting kit
The switches normally ship with rack-mounting
“ears” that allow installation into a two-post, 19-inch
datacomm rack.
Part number
Two-Post Rack-Mounting Kit for Switch 5406zl 5069-8561
Two-Post Rack-Mounting Kit for Switch 5412zl 5069-8562
Switch 3500/6200yl Rack-Mounting Kit 5069-5705
Two-Post Rack-Mounting Kit for Switch 8206zl 5070-6865
Two-Post Rack-Mounting Kit for Switch 8212zl 5070-2983
Switch zl Power Supply Shelf Rack-Mounting Kit 5070-3028
If installation using an HP 10000 Series four-post
19-inch cabinet is desired, a rack-mounting kit is
available providing rails that give sturdy support for
the switch along its entire length.
Part number
For 8200zl/5400zl—10K Rack Rail Kit Assembly 5070 -0145
For 3500/6200yl—10K Rack Rail Kit Assembly 356578- B21*
* Ordered through your HP sales channel
For transporting switches in a rack, please see the
Installation Guide that is included with the rack rail kits
for more instructions.
9