Product guide

Access Control Lists (ACLs) for the Series 5300xl Switches
Editing ACLs and Creating an ACL Offline
2. After you copy the above .txt file to a TFTP server the switch can access,
you would then execute the following command:
Figure 9-25. Example of Using “copy tftp command-file” To Configure an ACL in the Switch
Note If a transport error occurs, the switch does not execute the command and the
ACL is not configured.
3. Next, assign the new ACL to the intended VLAN which, in this example,
is for inbound traffic on VLAN 20.
ProCurve(config)# vlan 20 ip access-group “Controls
for VLAN 20" in
4. Inspect the new running configuration:
ProCurve(config)# show running
5. If the configuration appears satisfactory, save it to the startup-config file:
ProCurve(config)# write memory
9-58