System information

General System Configuration
Configuring SNMP
■ SNMPv3: Enables access for SNMPv3 clients. Access for SNMPv3 clients
is enabled by default.
■ SNMPv3 Only: Allows access for SNMPv3 clients only. Access for SNMP
v1 and v2c clients is disabled.
■ Location: A text string that describes the system location.
(Maximum length: 255 characters)
■ Contact: A text string that describes the system contact.
(Maximum length: 255 characters)
■ Community Name (Read/Write): Defines the SNMP community access
string that has read/write access. Authorized management stations are
able to both retrieve and modify MIB objects. (Maximum length: 32
characters, case sensitive; Default: private)
■ Community Name (Read Only): Defines the SNMP community access
string that has read-only access. Authorized management stations are only
able to retrieve MIB objects. (Maximum length: 32 characters, case sensi-
tive; Default: public)
To Enable SNMP and Set Parameters:
1. Select the Configuration tab.
2. Click the [
SNMP] button.
3. Select Enable for SNMP State to enable SNMP management.
4. For SNMPv3 Only, select Disable to enable access from SNMP v1 and v2c
clients.
5. Type text strings to replace the default community names for read-only
and read/write access. (Recommended for security.)
6. (Optional) Type a text string to identify the location of the access point in
the Location text field.
7. (Optional) Type a text string or name to identify a system administration
contact in the Contact text field.
8. Click the
[Apply Changes] button.
5-20