System information

General System Configuration
Setting Management Access Controls
Web: Configuring Management Controls
The Management window on the Administration tab enables management
access controls to be configured.
The web interface enables you to modify these parameters:
■ Reset Button: Enables or disables the access point’s Reset button.
■ Serial: Enables or disables management access through the access
point’s serial console port.
■ HTTP: Enables or disables management access through a Web browser
interface.
■ HTTP Port Number: Specifies the TCP port number used by the Web
browser interface.
■ HTTPS: Enables or disables management access through a secure Web
browser interface.
■ HTTPS Port Number: Specifies the TCP port number used by the secure
Web browser interface.
■ Telnet Server: Enables or disables management access through Telnet.
■ SSH Server: Enables or disables management access through a Secure
Shell version 2.0 client.
■ SSH Port Number: Specifies the TCP port number used by the SSH
server.
To Configure Management Control Settings:
1. Click the
[Management] button on the Administration tab.
2. As required, enable or disable the Reset button or serial port. To prevent
resetting the access point to factory defaults, set Reset Button to Disable.
When the Reset button is disabled, the serial port cannot be disabled.
3. As required, enable or disable the HTTP and HTTPS web servers. Note
that if you are using HTTP to configure the access point, your connection
will be lost when you disable the HTTP server.
4. As required, enable or disable the Telnet or SSH servers. If using SSH for
secure access to the CLI over a network connection, you may want to
disable the Telnet server.
5. Click the
[Apply Changes] button.
5-8