System information

Using the HP Web Browser Interface
Tasks for Your First HP Web Browser Interface Session
Tasks for Your First HP Web Browser
Interface Session
The first time you access the web browser interface, there are a number of
basic tasks that you should perform:
■ Set the Manager user name and password
■ Set the SNMP community names
■ Set the primary Service Set Identifier (SSID)
■ Enable radio communications and select a channel
■ Change TCP/IP settings
■ Set radio security options
Changing the Manager User Name and Password in the
Browser Interface
You may want to change both the Manager (Administrator) user name and
password to enhance access security for the management interface on your
access point. The Manager user name and password allows full read/write
access to the web browser interface.
The access point also allows the configuration of an Operator user name and
password with read-only access. For more information, see “Modifying
Management User Names and Passwords” on page 5-3.
No t e If you want security beyond that achieved with user names and passwords,
you can disable access to the web browser interface. This is done by executing
no http server and no https server at the Management Configuration level
command prompt in the CLI. Then, management access is only from the CLI,
through the console port or Telnet, or through SNMP.
To set the user name or password with the web browser interface:
1. Click the Administration tab and then the
[User] button.
4-8