System information

Using the Command Line Interface (CLI)
Using the CLI
Configuration Commands and the Context
Configuration Modes
You can execute basic configuration commands in the global configuration
mode. However, you must use a context mode to execute context-specific
commands.
The configuration options include management and interface (ethernet or
wireless) context modes:
Management Context . Includes specific commands that apply only to
management access to the access point. The prompt for this mode includes
the identity of the context:
HP420(config)#management Command executed at configuration
level for entering the management
context.
HP420(config-mgmt)# Resulting prompt showing the
management context.
HP420(config-mgmt)#? Lists the commands you can use in the
management context.
In the management context, the commands in the "?" listing
show the context-specific commands that apply only to
access point management.
HP420(config-mgmt)#?
Configure commands:
cli Set Command Line Interface parameters
end End config mode
exit Exit to previous mode
http Set IP HTTP server configuration
https Set IP HTTP secure server configuration
no Negate
password-admin Assign the privileged password myself(max length:16)
reset-button Set reset button parameters
snmpv3 Modify SNMPv3 parameters
ssh Set SSH Parameters
user User management
username-admin Set username myself
HP420(config-mgmt)#
Figure 3-6. Context-Specific Commands Affecting the Management Context
3-12