System information

File Transfers
Upgrade Procedure for v2.1.x Software
6. After a successful download, the prompt “Do you want to reset to FACTORY
DEFAULT SETTINGS? <y/n> [n]:” appears. Type “n” to retain the current
access point configuration. (Typing “y” restores factory default settings
and reboots the access point.)
7. Download the upgrade v2.1.x software file, hp420-2100Bxx.bin.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:hp420-2100B11.bin
TFTP Server IP:192.168.1.10
Removing old runtime! Please wait a few minutes!
Creating file! Please wait a few minutes!
Firmware version of system is v2.0.40-temp and Updating Run-
Time code v02.01.00 NOW!
Updating Boot Line in NVRAM, please wait!
Warning! Updating firmware may cause configuration settings
to be incompatible.
(Suggestion:Using new default configuration settings lets
system be more efficient,but system will lose current
settings.)
Do you want to reset to FACTORY DEFAULT SETTINGS? <y/n>
[n]:n
HP420#
8. After a successful download, the prompt “Do you want to reset to FACTORY
DEFAULT SETTINGS? <y/n> [n]:” appears. Type “n” to retain the current
access point configuration. (Typing “y” restores factory default settings
and reboots the access point.)
9. After all code files have been successfully downloaded, reboot the access
point.
HP420#reset board
Reboot system now? <y/n>: y
A-13