System information

Command Line Reference
VLAN Commands
Command Usage
• The management VLAN is for managing the access point through
remote management tools, such as the web interface, SNMP, SSH, or
Telnet. The access point only accepts management traffic that is
tagged with the specified management VLAN ID.
• Before enabling VLAN tagging on the access point, be sure to
configure the attached network switch port to support tagged VLAN
frames from the access point’s management VLAN ID, otherwise
connectivity to the access point will be lost.
• The access point supports only one untagged VLAN. If the manage-
ment VLAN is set to untagged, other SSID interface default VLANs
must be set to tagged.
Example
HP420(config)#management-vlanid 3 tagged
HP420(config)#
vlan-id
This command configures the default VLAN ID for an SSID interface.
Syntax
vlan-id <vlan-id> <tagged | untagged>
• vlan-id - Default VLAN ID. (Range: 1-4094)
• tagged - Client traffic is sent tagged with the VLAN ID. Received
client traffic must be tagged with the VLAN ID.
• untagged - Client traffic is sent untagged. Received untagged traffic
is passed to the SSID interface.
Default Setting
A created SSID interface is assigned the next available VLAN ID incre-
mented from 1.
Command Mode
SSID Wireless Interface Configuration
Command Usage
• When dynamic VLANs are enabled on the access point, a VLAN ID (a
number between 1 and 4094) can be assigned to each client after
successful authentication using IEEE 802.1X and a central RADIUS
8-132