System information

Command Line Reference
Neighbor AP Detection Commands
Neighbor AP Detection Commands
The access point can be configured to periodically scan all radio channels and
find other access points within range. Alternatively, the access point can scan
continuously in a dedicated mode with no clients supported. A database of
nearby access points is maintained where detected APs can be identified.
Command Function Mode Page
ap-detection Enables the periodic or dedicated detection of nearby GC 8-124
access points
ap-detection Sets the duration that all channels are scanned GC 8-125
duration
ap-detection Sets the time between each scan GC 8-126
interval
ap-detection first- Sets the time delay before scanning starts GC 8-126
scan
ap-detection Forces an immediate scan of all radio channels GC 8-127
instant-scan
show ap-detection Shows the current configuration for AP detection Exec 8-127
config
show ap-detection Shows the current database of detected access Exec 8-128
table points
ap-detection
This command enables the periodic detection of nearby access points.
Syntax
ap-detection <enable <periodic | dedicated> | disable>
• enable - Enables AP detection scanning.
– periodic - Specifies periodic AP detection scanning.
– dedicated - Specifies dedicated AP detection scanning.
• disable - Disables AP detection scanning.
Default Setting
Disabled
8-124