System information

Command Line Reference
Wireless Interface Commands
multicast-data-rate
This command configures the maximum data rate at which the access point
transmits multicast and broadcast traffic.
Syntax
multicast-data-rate <speed>
speed - Maximum rate allowed for multicast data. (Options: 1, 2, 5.5,
11 Mbps for b-only and b+g modes; 1, 2, 5.5, 6, 11, 12, 24 Mbps for
g-only mode)
Default Setting
1 Mbps for b-only and b+g modes
6 Mbps for g-only mode
Command Mode
Interface Configuration (Wireless)
Example
HP420(if-wireless g)#multicast-data-rate 2
HP420(if-wireless g)#
channel
This command configures the radio channel through which the access point
communicates with wireless clients.
Syntax
channel <channel | auto>
• channel - Manually sets the radio channel used for communications
with wireless clients.
– J8130A: The range is channels 1 to 11
– J8131A: The range is channels 1 to 14 depending on the country
setting
• auto - Automatically selects an unoccupied channel (if available).
Otherwise, the lowest channel is selected.
Default Setting
Automatic channel selection
Command Mode
8-101