System information

Command Line Reference
Wireless Interface Commands
Command Function Mode Page
preamble Sets the length of the signal preamble at the IC-W 8-107
start of a data transmission
transmit-limits Sets the reduction in transmit power required IC-W 8-107
for an external antenna to conform with local
regulations
transmit-power Adjusts the power of the radio signals IC-W 8-108
transmitted from the access point
max-association Configures the maximum number of clients that IC-W 8-109
can be associated with the access point at the
same time
shutdown Disables the wireless interface IC-W 8-110
enable Enables the SSID wireless interface IC-W-S 8-110
show interface wireless g Shows the status for the wireless interface Exec 8-111
show ssid Displays parameters for the specified SSID Exec 8-112
interface
show ssid-list Displays a list of current SSID interfaces Exec 8-113
show station Shows the wireless clients associated with the Exec 8-114
access point
interface wireless g
This command enters wireless interface configuration mode for configuring
parameters for the radio interface.
Syntax
interface wireless g
Default Setting
None
Command Mode
Global Configuration
Example
HP420(config)#interface wireless g
HP420(if-wireless g)#
8-94