System information

Command Line Reference
Wireless Interface Commands
Wireless Interface Commands
The commands described in this section configure global parameters for the
wireless interface.
Command Function Mode Page
interface wireless g Enters wireless interface configuration mode GC 8-94
mode
configured SSID
station can connect to the access point
access point can transmit multicast traffic
are transmitted from the access point
mode must wake up to receive broadcast/
multicast transmissions
be fragmented
must be sent to the receiving station prior to the
sending station starting communications
ssid add Adds an SSID interface IC-W 8-95
ssid Enters SSID wireless interface configuration IC-W 8-96
ssid-name Configures the service set identifier IC-W-S 8-96
primary Sets the SSID interface as the primary IC-W-S 8-97
description Adds a description to the wireless interface IC-W 8-97
closed-system Closes access to clients without a pre- IC-W-S 8-98
radio-mode Sets the radio working mode IC-W 8-99
antenna-mode Sets the access point’s antenna mode IC-W 8-99
speed Configures the maximum data rate at which a IC-W 8-100
multicast-data-rate Configures the maximum data rate at which the IC-W 8-101
channel Configures the radio channel IC-W 8-101
beacon-interval Configures the rate at which beacon frames IC-W 8-102
dtim-period Configures the rate at which stations in sleep
IC-W
8-103
fragmentation-length Configures the minimum packet size that can IC-W 8-104
rts-threshold Sets the packet size threshold at which an RTS
IC-W
8-105
slot-time Sets the basic unit of time the access point IC-W 8-106
uses for calculating transmission waiting times
8-93