System information

Command Line Reference
Ethernet Interface Commands
Ethernet Interface Commands
The commands described in this section configure connection parameters for
the Ethernet interface.
Command Function Mode Page
interface ethernet Enters Ethernet interface configuration mode GC 8-86
dns primary-server Specifies the primary name server IC-E 8-87
dns secondary-server Specifies the secondary name server IC-E 8-87
ip address Sets the IP address for the Ethernet interface IC-E 8-88
ip dhcp Submits a DHCP request for an IP address IC-E 8-89
shutdown Disables the Ethernet interface IC-E 8-90
speed-duplex Configures speed and duplex operation IC-E 8-90
show interface ethernet Shows the status for the Ethernet interface Exec 8-91
interface ethernet
This command enters Ethernet interface configuration mode for configuring
connection parameters for wired network.
Syntax
interface ethernet
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following
command:
HP420(config)#interface ethernet
HP420(if-ethernet)#
8-86