System information

Command Line Reference
MAC Address Authentication
Example
HP420(if-wireless-g-ssid-1)#mac-access permission denied
HP420(if-wireless-g-ssid-1)#
Related Commands
mac-access entry (page 8-79)
show authentication (page 8-76)
mac-access entry
This command enters or removes MAC address from the filter table.
Syntax
mac-access entry <mac-address> <active | inactive | deleted>
• mac-address - Physical address of a client. Enter six pairs of hexa-
decimal digits separated by hyphens, e.g., 00-90-D1-12-AB-89.
• active - Adds the MAC address to the filter table as an active entry.
• inactive - Adds the MAC address to the filter table as an inactive
entry.
• deleted - Removes the MAC address entry from the filter table.
Default
None
Command Mode
SSID Wireless Interface Configuration
Command Usage
• Software version 2.0.37 or earlier supports up to only 256 MAC
addresses in the local filter table. Software version 2.0.38 or later
supports up to 1024 MAC addresses.
• An active MAC address entry in the filter table may be allowed or
denied access depending on the global setting configured for the table
using the mac-access permission command.
Example
HP420(if-wireless-g-ssid-1)#address filter entry 00-70-50-
cc-99-1a allowed
HP420(if-wireless-g-ssid-1)#
8-79