System information

Command Line Reference
SNMP Commands
– sysRadiusServerChanged - The access point has changed from
the primary RADIUS server to the secondary, or from the
secondary to the primary.
– sysSystemDown - The access point is about to shutdown and
reboot.
– sysSystemUp - The access point is up and running.
– vlanEnableStatusSet - VLAN support on the access point has
been enabled or disabled.
– vlanUntaggedSet - VLAN support on the access point has been
set to untagged.
– wirelessExternalAntenna - An external antenna has been
attached or detached from the access point.
– hpdot11BeaconTransmissionOk – The access point has resumed
transmitting beacon frames after an RF pollution condition has
cleared.
– hpdot11BeaconTransmissionFail – The access point cannot
transmit beacon frames due to RF pollution on the radio
channel.
– sshEnableStatusSet – The access point’s SSH server has been
enabled or disabled.
– radiusAcctEnableStatusSet – RADIUS Accounting on the access
point has been enabled or disabled.
– qosSvpEnableStatusSet – SpectraLink Voice Priority support has
been enabled or disabled.
Default Setting
All traps enabled
Command Mode
Global Configuration
Command Usage
This command is used in conjunction with the snmp-server host and snmp-
server enable server commands to enable SNMP notifications.
Example
HP420(config)#snmp-server trap hpdot11StationAssociation
HP420(config)#
8-45