System information

Command Line Reference
SNMP Commands
Command Usage
The snmp-server host command is used in conjunction with the snmp-server
enable server command to enable SNMP notifications.
Example
HP420(config)#snmp-server host 1 10.1.19.23 batman
HP420(config)#
Related Commands
snmp-server enable server (page 8-41)
snmp-server trap
This command enables the access point to send specific SNMP traps (i.e.,
notifications) to SNMP v1 and v2c hosts and v3 targets. Use the no form to
disable specific trap messages.
Syntax
snmp-server trap <trap>
no snmp-server trap <trap>
trap - One of the following SNMP trap messages:
– adHocDetected - An adhoc wireless network has been detected
during a neighbor AP scan.
– apScanDoneAndNewApDetected - A periodic AP scan has
completed or dedicated AP scanning has detected new
neighbor APs.
– apScanEnableStatusSet - Neighbor AP detection has been
enabled or disabled.
– apScanNow - An instant neighbor AP scan has been requested.
– cliSerialPortEnableStatusSet - Management access through the
serial port has been enabled or disabled.
– cliTelnetPortEnableStatusSet - Management access through
Telnet has been enabled or disabled.
– hpdot11InterfaceFail - The 802.11g interface has failed.
– hpdot11StationAssociation - A client station has successfully
associated with the access point.
– hpdot11StationAuthentication - A client station has been success-
fully authenticated.
– hpdot11StationReAssociation - A client station has successfully
re-associated with the access point.
8-43