System information

Command Line Reference
System Logging Commands
System Logging Commands
These commands are used to configure system logging on the access point.
Command Function Mode Page
logging on Controls logging of error messages GC 8-28
logging host Adds a syslog server host IP address that will receive GC 8-29
logging messages
logging console Initiates logging of error messages to the console GC 8-29
logging level Defines the minimum severity level for event logging GC 8-30
logging facility- Sets the facility type for remote logging of syslog GC 8-31
type messages
logging clear Clears all log entries in access point memory GC 8-31
show event-log Displays all log entries in access point memory Exec 8-32
show logging Displays the state of logging Exec 8-32
logging on
This command controls logging of error messages, i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
logging on
no logging
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can
use the logging level command to control the type of error messages that
are stored in memory.
8-28