System information

Command Line Reference
System Management Commands
Command Usage
• When enabled, the access point identifies voice traffic by the Spec-
traLink Radio Protocol identifier in the IP header of the frame. The
system requires support of SVP-enabled VoIP wireless phones and a
SpectraLink NetLink SVP Server on the wired network.
• The number of SVP-enabled wireless phones that can be supported
simultaneously by a single access point has a theoretical limit of
seven. However, the practical limited is five, which still allows some
bandwidth for other data traffic.
• When using SVP on the access point, set the radio fragmentation
threshold to 584 or higher. See “fragmentation-length” on page 8-104.
Example
HP420(config-mgmt)#svp
HP420(config-mgmt)#
show svp
This command displays the current SVP setting.
Command Mode
Exec
Example
HP420#show svp
SVP: Disabled
HP420#
show system
This command displays basic system configuration settings.
Default Setting
None
Command Mode
Exec
8-25