System information

Command Line Reference
System Management Commands
Command Mode
Management Configuration
Command Usage
• Use the snmpv3 only command to disable access for SNMP v1 and v2c
clients.
• Use the no snmpv3 only command to enable access for SNMP v1 and
v2c clients.
• Use the snmpv3 enable command to enable access for SNMP v3 clients.
• Use the no snmpv3 enable command to disable access for SNMP v3
clients.
Example
HP420(config-mgmt)#snmpv3 only
HP420(config-mgmt)#
reset-button enable
This command enables the access point’s reset button. Use the no form to
disable the reset button.
Syntax
reset-button enable
no reset-button
Default Setting
Enabled
Command Mode
Management Configuration
Command Usage
The access point’s reset button and serial port cannot be disabled at the
same time. When the serial port is disabled, it is not possible to disable
the reset button using this command.
8-20