System information

Command Line Reference
System Management Commands
Command Mode
Exec
Command Usage
• The access point’s Country Code must be set before the radio can be
enabled.
• The available Country Code settings can be displayed by using the
country ? command.
• The Country Codes US (United States) and CA (Canada) are effec-
tively the same setting and are both implemented as NA (North
America).
• Setting the Country Code requires a system reboot.
• After a Country Code has been set and the system rebooted, the
country command is no longer available from the CLI. If you need to
change the Country Code, the access point configuration must be
reset to its default values by using the reset configuration command,
or by pressing the reset button for more than five seconds.
Example
HP420#country gb
Reboot system now to make the country code change effective?
<y/n>: y
Reboot system...
prompt
This command customizes the CLI prompt. Use the no form to restore the
default prompt.
Syntax
prompt <string>
no prompt
string - Any alphanumeric string to use for the CLI prompt.
(Maximum length: 255 characters)
Default Setting
HP ProCurve Access Point 420
8-12