System information

Wireless Security Configuration
Using the Security Wizard
The following example shows how to configure access point security for WPA-
PSK mode. Supported clients must be WPA-enabled and configured with the
same pre-shared key.
HP420(if-wireless-g-ssid-1)#security-suite 3 wpa
HP420(if-wireless-g-ssid-1)#wpa-preshared-key ASCII a very
good secret key
HP420(if-wireless-g-ssid-1)#
Alternatively, you can use the following security-suite command to configure
WPA-PSK (AES) mode for WPA2 clients without using the wizard option:
HP420(if-wireless-g-ssid-1)#security-suite open-system
wpa-required psk aes-aes wpa2
Using the CLI to Configure Dynamic WEP Keys. The following exam-
ple shows how to configure an SSID interface to use dynamic WEP keys using
802.1X for authentication and key management. The security-suite command
wizard option 5 can be used to set the security parameters. The 802.1X
broadcast and session key refresh rates and a re-authentication timeout are
also set.
This example assumes that a RADIUS server is configured and available on
the wired network, it also assumes that the RADIUS server parameters are
configured on the access point.
HP420(if-wireless-g-ssid-1)#security-suite 5
HP420(if-wireless-g-ssid-1)#802.1x broadcast-key-refresh-
rate 5
HP420(if-wireless-g-ssid-1)#802.1x session-key-refresh-rate
5
HP420(if-wireless-g-ssid-1)#802.1x session-timeout 600
HP420(if-wireless-g-ssid-1)#
Alternatively, you can use the following security-suite command to configure
dynamic WEP encryption without using the wizard option:
HP420(if-wireless-g-ssid-1)#security-suite open-system
wpa-disabled 802.1x-required
7-22