System information

General System Configuration
Configuring VLAN Support
CLI: Enabling VLAN Support
CLI Commands Used in This Section
Command Syntax CLI Reference Page
[no] vlan enable <static | dynamic> page 8-130
management-vlanid <vlan_id> <tagged | untagged> page 8-132
show system page 8-25
The following example shows how to set the management VLAN ID and enable
VLAN support. Note that to enable or disable VLAN support, you must reboot
the access point.
HP420(config)#management-vlanid 9 tagged
HP420(config)#vlan enable static
Reboot system now? <y/n>:
5-65