System information

General System Configuration
Configuring Ethernet Interface Parameters
To display the current Ethernet interface status from the Exec level, use the
show interface ethernet command, as shown in the following example.
HP420#show interface ethernet
Ethernet Interface Information
===========================================================
IP Address : 10.1.0.1
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
Primary DNS : 0.0.0.0
Secondary DNS : 0.0.0.0
Speed-duplex : 100Base-TX Full Duplex
Admin status : Up
Operational status : Up
===========================================================
HP420#
5-51