System information

General System Configuration
Enabling System Logging
Web: Setting Logging Parameters
The System Servers window on the Administration tab enables system logs and
Syslog server details to be configured for the access point.
The web interface enables you to modify these parameters:
■ System Log Setup: Enables the logging of error messages.
■ Server (1 to 4): Enables the sending of log messages to Syslog server
hosts. Up to four Syslog servers are supported on the access point.
■ Name/IP: The IP address or name of a Syslog server.
■ UDP Port: The UDP port used by a Syslog server.
■ Logging Console: Enables the logging of error messages to the console.
■ Logging Level: Sets the minimum severity level for event logging
No t e To view log messages generated by the access point, click the [Event Log] button
on the Status
tab. See “Event Log” on page 4-23.
To Enable Logging:
1. Select the Administration tab.
2. Click the [
System Servers] button.
3. For System Log Setup, select Enable.
4. For Logging Level, select the minimum severity level to be logged.
5. (Optional) If you want to send log messages to a Syslog server, perform
these steps:
a. Set one of the Server parameters to Enable.
b. In the Name/IP field, type the IP address or name of the Syslog server.
c. Set the UDP port used by the Syslog server.
6. (Optional) If you want to send log messages to the console, set Logging
Console to Enable.
7. Click the
[Apply Changes] button.
5-41