System information

General System Configuration
Configuring SNMP
To send SNMP v1 and v2c traps to a management station, specify the host IP
address using the snmp-server host command and enable specific traps using
the snmp-server trap command.
HP420(config)#snmp-server host 1 192.168.1.10 private
HP420(config)#snmp-server host 2 192.168.1.19 private
HP420(config)#snmp-server trap dot11stationassociation
HP420(config)#snmp-server trap dot11stationauthentication
HP420#
To display the current SNMP settings from the Exec level, use the show snmp-
server command, as shown in the following example.
HP420#show snmp-server
SNMP Information
==============================================
Service State : Enable
Community (ro) : *****
Community (rw) : *****
Location : WC-19
Contact : Paul
Version Filter : Enable SNMPv1, SNMPv2c
: Disable SNMPv3
EngineId :00:00:00:0b:00:00:00:0d:9d:c6:98:7e
EngineBoots:13
Trap Destinations:
1: 192.168.1.10, Community: *****, State: Enabled
2: 192.168.1.19, Community: *****, State: Enabled
3: 0.0.0.0, Community: *****, State: Disabled
4: 0.0.0.0, Community: *****, State: Disabled
hpdot11StationAssociation Enabled
hpdot11StationAuthentication Enabled
hpdot11InterfaceFail Enabled
dot1xMacAddrAuthFail Enabled
dot1xAuthSuccess Enabled
localMacAddrAuthSuccess Enabled
iappStationRoamedFrom Enabled
iappContextDataSent Enabled
sysSystemUp Enabled
sysRadiusServerChanged Enabled
hpdot11StationReAssociation Enabled
hpdot11StationRequestFail Enabled
dot1xMacAddrAuthSuccess Enabled
dot1xAuthNotInitiated Enabled
dot1xAuthFail Enabled
localMacAddrAuthFail Enabled
iappStationRoamedTo Enabled
sntpServerFail Enabled
sysSystemDown Enabled
sysConfigFileVersionChanged Enabled
5-38