System information

General System Configuration
Configuring SNMP
• vlanEnableStatusSet – VLAN support on the access point has been
enabled or disabled. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.30)
• vlanUntaggedSet – VLAN support on the access point has been set
to untagged. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.31)
• mgntVlanIdSet – The access point’s management VLAN ID has been
changed. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.32)
• adHocDetected – An adhoc wireless network has been detected
during a neighbor AP scan.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.38)
• ssidPrimarySet – The access point’s primary SSID has been
changed. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.34)
• apScanDoneAndNewApDetected – A periodic AP scan has
completed or dedicated AP scanning has detected new neighbor APs.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.35)
• apScanEnableStatusSet – Neighbor AP detection has been enabled
or disabled. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.36)
• apScanNow – An instant neighbor AP scan has been requested.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.37)
• hpdot11BeaconTransmissionOk – The access point has resumed
transmitting beacon frames after an RF pollution condition has
cleared. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.38)
• hpdot11BeaconTransmissionFail – The access point cannot
transmit beacon frames due to RF pollution on the radio channel.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.39)
• sshEnableStatusSet – The access point’s SSH server has been
enabled or disabled. (Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.40)
• radiusAcctEnableStatusSet – RADIUS Accounting on the access
point has been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.41)
• qosSvpEnableStatusSet – SpectraLink Voice Priority support has
been enabled or disabled.
(Object ID: 1.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.42)
To Configure SNMP Trap Destinations:
1. Select the Configuration tab.
2. Click the [
SNMP Trap] button.
3. Type the IP address in the Trap Destination IP Address field and specify one
of the configured community names in the Trap Destination Community
Name field.
5-36