System information

General System Configuration
Configuring SNMP
• UDP Port – The UDP port that is used on the receiving management
station for trap messages.
• SNMP User – The defined SNMP v3 user that is to receive trap
messages. (Note that SNMP v3 users must first be defined.)
• Assigned Filter – The name of a user-defined trap filter that is
applied to the target. If no filter is assigned to the target, all traps are
sent.
■ SNMP Trap Filters: Configures SNMP v3 trap filters.
• Filter ID – A user-defined name that identifies the filter. (Maximum
length: 32 characters)
• Subtree OID – Specifies the MIB subtree to be filtered. The OID can
specify one trap or include all the traps under the OID subtree. The
MIB subtree must be defined in the form “.1.3.6.1” and always start
with a “.”. A full list of supported traps and OIDs are provided on page
5-33. The
[Edit] button can be used to add up to 20 OID subtrees to the
same filter.
• Filter Type – Indicates if the MIB subtree traps specified by the
Subtree OID are to be sent to the receiving target.
– Include: The MIB subtree traps are to be sent to the assigned
receiving target.
– Exclude: The MIB subtree traps are not to be sent to the assigned
receiving target.
5-28