Specifications

Getting Started With Access Point Configuration
11. Type configure to return to global configuration mode, and then type
interface wireless g to access the wireless interface-configuration mode.
HP ProCurve Access Point 420#configure
Enter configuration commands, one per line. End with CTRL/Z
HP ProCurve Access Point 420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless g)#
12. Set the Service Set Identifier (SSID) to identify the communications
domain for the access point. Type ssid identifier, where identifier can consist
of up to 32 alphanumeric characters and is case sensitive.
HP ProCurve Access Point 420(if-wireless g)#ssid 420
HP ProCurve Access Point 420(if-wireless g)#
13. Set the radio channel through which the access point communicates with
its wireless clients. Use the default setting (auto) to have the access point
automatically select the first available channel. Otherwise, type channel
number, where number can be from 1 to 14, depending on the wireless
regulations specified by your country.
HP ProCurve Access Point 420(if-wireless g)#channel 9
HP ProCurve Access Point 420(if-wireless g)#
Not e All settings are immediately saved and retained on a reboot.
Point Configuration
Getting Started With Access
3-5