Specifications

Getting Started With Access Point Configuration
9. Type exit to leave configuration mode, then type the show interface wire-
less g command to display the access point’s default wireless configura-
tion, including wireless communication domain, radio channel, and
operation status. The following illustration shows the default settings.
HP ProCurve Access Point 420(if-ethernet)#exit
HP ProCurve Access Point 420#show interface wireless g
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description : Enterprise 802.11g Access Point
SSID : Enterprise Wireless AP
Radio mode : 802.11b + 802.11g
Channel : 0 (AUTO)
Status : Disabled
----------------802.11 Parameters--------------------------
Transmit Power : FULL (5 dBm)
Max Station Data Rate : 54Mbps
Fragmentation Threshold : 2346 bytes
RTS Threshold : 2347 bytes
Beacon Interval : 100 TUs
DTIM Interval : 2 beacons
Maximum Association : 128 stations
----------------Security-----------------------------------
Closed System : DISABLED
WPA mode : Dynamic key
Multicast cipher : WEP
Unicast cipher : TKIP
WPA clients : SUPPORTED
Authentication Type : OPEN
Encryption : DISABLED
Default Transmit Key : 1
WEP Key Data Type : Hexadecimal
Static Keys :
Key 2: EMPTY Key 3: EMPTY Key 4: EMPTY
===========================================================
HP ProCurve Access Point 420#
Getting Started With Access
Point Configuration
10. If you are using the HP ProCurve Wireless Access Point 420 na (J8130A)
model sold in the United States, radio channels 1 - 11 are the only options
supported under FCC regulations, and cannot be changed. However, if
you are using HP ProCurve Wireless Access Point 420 ww (J8131A) model
sold in other countries, then you need to set the country code to indicate
the channels permitted for you area. The wireless radio is automatically
enabled once a country code is set.
First type country ? to display the list of countries. Select the code for your
country, and enter the country command again, followed by your country
code (e.g., GB for Great Britain).
HP ProCurve Access Point 420#country gb
HP ProCurve Access Point 420#
3-4