Product guide

IP Routing Features
Configuring DHCP Relay
Viewing the Current DHCP Relay Configuration
Determining the DHCP Relay Setting. Use show config (or show running
for the running-config file) to list the current DHCP Relay setting. Note that
because DHCP Relay is enabled in the default configuration, it does not appear
in these listings unless it is disabled.
ProCurve Switch 2900-24G(config)# show config
Startup configuration:
; J9049A Configuration Editor; Created on release #T.11.XX
hostname "ProCurve Switch 2900-24G"
module 3 type J8694A
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-24,A1-A4
ip address dhcp-bootp
exit
no dhcp-relay
Non-Default DHCP-Relay Setting
Figure 3-11. Example of Startup-Config Listing with DHCP-Relay Disabled
Listing the Currently Configured DHCP Helper Addresses.
Syntax: show ip helper-address < vlan-id >
This command shows the currently configured IP Helper addresses, regard-
less of whether DHCP-Relay is enabled. For example:
Figure 3-12. Example of Listing for IP Helper Addresses
3-40