Specifications

Redundant Links
Rev. 9.41 Module 5 – 143
Lab — Enable STP on a 5406zl switch and configure a bridge
priority of 0 to make this switch the root bridge
You can perform the below mentioned steps to enable STP on a 5406zl switch and
configure a bridge priority of 0 to make this switch the root bridge. You will then use
the show spanning-tree command to view information about the STP network.
For this simulation, a serial connection has been established with the 5406zl switch,
and you are at the manager-level context.
1. Move to the global configuration context.
ProCurve Switch 5406zl# configure terminal
2. Enable STP on the switch.
ProCurve Switch 5406zl# (config) # spanning-tree
3. Configure a bridge priority of 0 to make this switch the root bridge.
ProCurve Switch 5406zl# (config) # span priority 0
4. Display information about the STP network.
ProCurve Switch 5406zl# (config) # show spanning-tree
5. Save your configuration changes.
ProCurve Switch 5406zl# (config) # write memory
For HP Internal Use Only