Installation guide

37
Enhancements
Release Y.11.16 Enhancements
RADIUS Authentication Statistics
Figure 10. Example of Login Attempt and Primary/Secondary Authentication Information from the Show
Authentication Command
Figure 11. Example of RADIUS Authentication Information from a Specific Server
Syntax: show authentication
Displays the primary and secondary authentication meth-
ods configured for the Console, Telnet, Port-Access (802.1X),
and SSH methods of accessing the switch. Also displays the
number of access attempts currently allowed in a session.
show radius authentication
Displays NAS identifier and data on the configured RADIUS
server and the switch’s interactions with this server.
(Requires prior use of the radius-server host command to
configure a RADIUS server IP address in the switch. See
“Configuring RADIUS Accounting” on page 26.)
ProCurve(config)# show authentication
Status and Counters - Authentication Information
Login Attempts : 3
Respect Privilege : Disabled
| Login Login Enable Enable
Access Task | Primary Secondary Primary Secondary
----------- + ---------- ---------- ---------- ----------
Console | Local None Local None
Telnet | Radius None Radius None
Port-Access | Local None
Webui | Local None Local None
SSH | Radius None Radius None
Web-Auth | ChapRadius None
MAC-Auth | ChapRadius None
ProCurve(config)# show radius authentication
Status and Counters - RADIUS Authentication Information
NAS Identifier : ProCurve
Invalid Server Addresses : 0
UDP
Server IP Addr Port Timeouts Requests Challenges Accepts Rejects
--------------- ----- ---------- ---------- ---------- ---------- ----------
192.33.12.65 1812 0 2 0 2 0