Installation guide

33
Enhancements
Release Y.11.16 Enhancements
Example. If the switch is configured with RADIUS accounting on the switch to use start-stop for
Exec, System, and Command functions, as shown in figure 6, there will be an “Accounting-On” record
when the switch boots up and an “Accounting-Off” record when the switch reboots or reloads.
(Assume that Acct-Session-Id is configured for common.)
Figure 6. Example of Accounting Session Operation with “start-stop” Enabled
4. (Optional) Configure Session Blocking and Interim Updating Options. These optional
parameters give you additional control over accounting data.
• Updates: In addition to using a Start-Stop or Stop-Only trigger, you can optionally
configure the switch to send periodic accounting record updates to a RADIUS server.
• Suppress: The switch can suppress accounting for an unknown user having no user
name.
Acct-Session-Id = "003600000001"
Acct-Status-Type = Accounting-On
NAS-IP-Address = 1.1.1.15
NAS-Identifier = "gsf_dosx_15"
Acct-Delay-Time = 5
Acct-Session-Id = "003600000002"
Acct-Status-Type = Start
Service-Type = NAS-Prompt-User
Acct-Authentic = Local
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
Calling-Station-Id = "0.0.0.0"
Acct-Delay-Time = 0
Acct-Session-Id = "003600000002"
Acct-Status-Type = Interim-Update
Service-Type = NAS-Prompt-User
Acct-Authentic = Local
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
NAS-Port-Type = Virtual
Calling-Station-Id = "0.0.0.0"
HP-Command-String = "reload"
Acct-Delay-Time = 0
Acct-Session-Id = "003600000001"
Acct-Status-Type = Accounting-Off
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
Acct-Delay-Time = 0
Record of Switch Bootup
Record of System Accounting Off
When Switch Reboots
Record of reload Command Issued
Record of User Session Start